Modeling motor control - Chief Delphi

Place a corner of it on the end of a table, clamp down the other side, and have a good whack at it with a hammer (hard). If it didn't break, it was polycarbonate. - vivek16 [more]

		Chief Delphi > Technical > Motors
Modeling motor control

Thread Tools

Rate Thread

Display Modes

#17

05-01-2011, 02:05

kamocat

Test Engineer

AKA: Marshal Horn

FRC #3213 (Thunder Tech)

Team Role: Mentor

Join Date: May 2008

Rookie Year: 2008

Location: Tacoma

Posts: 894

Re: Modeling motor control

Thank you for the straightforward answers.

Quote:

Originally Posted by Ether

Quote:

Originally Posted by kamocat

Will 5A at 4v produce the same internal torque as 5A at 10v?

To a very good approximation, yes, as long as we're talking about the same waveform of 5A in each case.

How would I measure it in a way that any waveform with the same current would create the same torque? You said algebraic average?

__________________
-- Marshal Horn

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Encoder Motor Control	Wicked	NI LabVIEW	3	11-02-2009 18:21
Motor control problem	Lablabla	Programming	3	17-01-2007 15:27
Motor Control Systems	Astronouth7303	Programming	3	05-04-2005 19:35
Four motor control	judson	Programming	1	14-02-2005 20:17
Motor Control	archiver	2000	1	23-06-2002 23:01

All times are GMT -5. The time now is 14:20.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.