|
|
|
 Your drivetrain might make my girlfriend break up with me :D - Tottanka [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Your drivetrain might make my girlfriend break up with me :D - Tottanka [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#5
05-01-2011, 10:48
|
|||
|
|||
|
Re: LabVIEW PID uses derivative of Process Variable
Jared and Greg are correct. The modification is actually very common on industrial PIDs to avoid the 'derivative kick' from setpoint changes. In the literature, this is also called PI-D controller or even 2-Degree of Freedom PID. Here is some literature that could be useful in the future:
http://www.cds.caltech.edu/~murray/c...astrom-ch6.pdf 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview PID | Gary Bonner | NI LabVIEW | 1 | 18-02-2010 20:31 |
| Traction control: How do I tune a PID controller with variable gain? | windell747 | Programming | 17 | 22-03-2009 21:18 |
| How do i find a variable and use it on Labview | Chris11246 | NI LabVIEW | 23 | 21-01-2009 17:50 |
| Variable rollover with Labview (suggestions?) | kamocat | NI LabVIEW | 7 | 22-08-2008 08:30 |
| Two variable PID? I know someone's done it =)... | Mr. Lim | Programming | 4 | 29-08-2006 00:31 |
Threaded Mode