Peg height question?

[EricH]

Assume that it doesn't matter. Note that there is an 8" offset between adjacent pegs so design for that to be included.

You can also try the official field drawings (after the FIRST website comes back up!)

[IronHorse 2761]

It does matter, because people might base their robot height off of how high the top pegs are.

[EricH]

Originally Posted by IronHorse 2761

It does matter, because people might base their robot height off of how high the top pegs are.

True.

It looks like the middle (elevated) pegs are about the 6.5-7 ft mark. The lower ones are about the 3.5' mark. The upper ones would then be about the 9.5-10 ft mark. This is for the tall ones; the others are about 8" lower.

[Superllama12]

Thanks so much!!!

[darkangel]

Has anyone seen if the field diagrams are posted/downloaded them so they have the exact heights?

[Superllama12]

Originally Posted by darkangel

Has anyone seen if the field diagrams are posted/downloaded them so they have the exact heights?

No, I have been refreshing literally every five minutes, I was hoping that someone else would be able to pull it up so that they can let me know (as I don't have inventor on it). If anyone does find out, please let me know. Thanks!