|
|
|
 If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#2
22-10-2002, 05:28
|
||||||
|
||||||
|
Pulleys V Belts
Many styles, sizes and hub sizes are available at your local ACE hardware store or any general hardware store. Not Home depot or Lowes.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What problems have you encountered using treads? | M.I. | Technical Discussion | 8 | 15-01-2002 22:13 |
| Dual Sided Timing Belts | Lachuck894 | Technical Discussion | 9 | 14-01-2002 10:10 |
| Belts, Timing Belts, and Automobiles. | Anton Abaya | Technical Discussion | 5 | 09-01-2002 19:21 |
Linear Mode
