Quote:
Originally Posted by Sunshine
"and the cutout cannot be more than 8 inches wide. See <R07> A and K, including Figure 4-3."
I believe that your interpretation is incorrect. <R07> and the corresponding pictures is describing the backing needed for the bumpers.
|
Can you explain how I misinterpreted this?
Quote:
|
Originally Posted by <R07-K>
The BUMPER backing must be supported by the structure/frame of the ROBOT (i.e. the gap between the backing material and the frame must not be greater than 1/4” and no section of BUMPER greater than 8” may be unsupported).
|
Your team will be more of a team and not a group of students who are just building a robot. Instead of being in FIRST, you will be FIRST. - JackN [more] 
11-01-2011, 08:57
(since 2004)
Threaded Mode