Minibot non-slip pad question

If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more]

		Chief Delphi > Technical > Kit & Additional Hardware
Minibot non-slip pad question

Thread Tools

Rate Thread

Display Modes

12-01-2011, 17:31

robotics1208 robotics1208 is offline

Registered User

FRC #1028

Join Date: Jan 2011

Location: O'Fallon

Posts: 7

robotics1208 is an unknown quantity at this point

Minibot non-slip pad question

Are we allowed to use the non-slip pads and extend its use for a non-slip belt for grip on the wheels?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:27.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.