|
|
|
 Right now that dream is sealed behind a few milimeters of plastic for most teams. - AllenGregoryIV [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Right now that dream is sealed behind a few milimeters of plastic for most teams. - AllenGregoryIV [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
First Touch I/O Module
We have an idea to use analog outputs from 3 different sources for the drivers station, however we do not know how to program the First Touch I/O Module. Some basic code, or where to get some would be very much appreciated.
-Team 2460 
|
|
#2
12-01-2011, 18:19
|
|||||
|
|||||
|
Re: First Touch I/O Module
How To Configure Your I/O Module
Source Code - WPI That should get you started. I am not in the programming section of the robot but I believe that most of the info can be used from these. Check the pages on here as well. They should provide you with some answers.  Last edited by rcmolloy : 12-01-2011 at 18:22.
|
|
#3
13-01-2011, 02:12
|
|||
|
|||
|
Re: First Touch I/O Module
The most direct way to do this is to configure the I/O board as normal, then simply read the analogs you want on the robot. You don't mention a language, but all have access to the FT values via the DriverStation object or library.
On the robot, do the math to combine them into the appropriate control values e.g. speed= (x+y+z)/3, or whatever you need. Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
