Quote:
Originally Posted by Retired Starman
To determine once and for all what the peg heights are, go to this link:
http://www.usfirst.org/roboticsprogr....aspx?id=18763
...
Plans are also on this site for team-built pipes made from PVC plastic pipe. Be careful when you make the pipes out of plastic. Not all tee-fittings are the same size, and pipe doesn't always bottom out when glued into the tee-fittings, so be sure to measure the finished products when you make them. |
You should assemble, then measure your rack pipes before taking them apart for application of glue and reassembly into their
final configuration. Also be sure to have a plan for keeping the pegs all going in the same plane. Marks on the fitting Tees and pvc tubes will help with alignment. Keep a sharpie marker handy.
If you have an opinion on something, it often says more about you than it does that thing. - JVN [more] 
13-01-2011, 22:16
Threaded Mode