pic: Team 148 - 2011 - Raptor

[JesseK]

Hmm. More compactness (potentially):

1. Fix 2 long VEX metal pieces to the dead axle of the arm such that one of the square holes is concentric with the axle. The hole will have to be enlarged of course. The two pieces of metal should be far enough apart that the slop is minimized, regardless of whether the potentiometer gear is cantilevered or dual-supported.
2. Attach the VEX gear to the arm, as shown.
3. Attach the potentiometer and the potentiometer gear to the VEX metal using appropriate spacing for the chosen gears. The spacing is built-in since it's VEX.
4. Profit.

We've always had issues with potentiometers since we can't seem to keep them from slipping in the shafts we directly mount them to (thus needing to recalibrate them). Or the rubber band / polycord belts we make slip. It results in a bad calibration. Maybe we can try VEX this off season. Right now we use limit switches with encoders -- not too bad coding-wise, but man that's a lot of little wires to run.