|
|
|
 Creatively solving problems is part of the fun. Continuous improvement and sustainment of [old] programs is also important. - tim-tim [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Creatively solving problems is part of the fun. Continuous improvement and sustainment of [old] programs is also important. - tim-tim [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
30-08-2011, 12:49
|
|||||
|
|||||
|
Re: pic: 254/968 More Swerve Parts!
We have made shafts similar to these since 2007. The 2006 shafts were slightly simpler and didn't have the 5/8" hex. Each year the shaft changes slightly as well, usually to accommodate differing gearbox configurations, wheel width changes, etc.
The tolerance on the hex portions of these shafts is +-.0005, but that may be overkill depending on the precision you require and the amount of slop you deem acceptable. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 254/968 Unfinished Parts (1) | Cory | Extra Discussion | 7 | 16-01-2008 17:57 |
| pic: 254/968 Machined Parts | Cory | Extra Discussion | 1 | 08-01-2008 12:16 |
| pic: 254/968 Machined Parts | Cory | Robot Showcase | 11 | 12-02-2007 07:42 |
| pic: more unfinished parts... 254/968 | ejSabathia | Extra Discussion | 1 | 03-02-2007 12:16 |
| pic: Anodized Parts 254/968... | ejSabathia | Extra Discussion | 12 | 02-02-2007 15:31 |
Threaded Mode