paper: Shooter Wheel Speed Control

Throughout the "FIRST" experience we're all taught that if we try hard we'll achieve some level of success down the road; it hits everyone differently. - nlknauss [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
paper: Shooter Wheel Speed Control

Thread Tools

Rate Thread

Display Modes

#13

17-04-2012, 14:50

Ether

systems engineer (retired)

no team

Join Date: Nov 2009

Rookie Year: 1969

Location: US

Posts: 7,986

Re: paper: Shooter Wheel Speed Control

Quote:

As for the biggest loads being in the initial spin up, I made it where we always spun at a minimum of 500 RPM, so it would never have to pull too much current again.

Are you talking about the bang-bang controller here? And are you saying that you did not set the motor voltage to 0, but rather set it to some small non-zero value, even when at the control point?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.