|
|
|
 I still have 3 good ligaments left and 2 events, so I should be fine :rolleyes: - esquared [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I still have 3 good ligaments left and 2 events, so I should be fine :rolleyes: - esquared [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#26
29-08-2012, 17:22
|
||||
|
||||
|
Re: pic: 2012 frc971 transmission
For those who are using/have used belts in their drivetrain, what belt/pulley combinations have worked well? I'm assuming everyone is using the 5mm GT2 profile, but I've seen a good amount of variance in belt width and pulley diameter.
We're currently working on a drivetrain based around 15mm wide 5mm GT2 belts, and 20T pulleys. The gates website has a lot of information regarding the rated load capacity of different profiles/belt/pulley combinations, and it looks like 20T pulleys should be sufficient, but some real world experience would be helpful. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode