|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#20
|
||||
|
||||
|
Re: pic: Sheet Metal with VexPro parts
Super snazzy.
For someone of us that haven't had a chance to take these parts for a spin in Inventor, what's the output shaft length on those gearboxes? What's the distance between those railings? And, just for general sheet metal design is "safe" (for lack of a better word) to use dead axle bolts directly like that on a sheet so thin? - Sunny G. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|