|
|
|
 Ha, our 2009 robot's nickname was Sparky, for the same reason...we now have EXTRA fire extinguishers because of it ;P - Karibou [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ha, our 2009 robot's nickname was Sparky, for the same reason...we now have EXTRA fire extinguishers because of it ;P - Karibou [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
21-01-2013, 14:49
|
||||
|
||||
|
Re: pic: GT2 Pulleys
The pulleys were completely machined by me, the stock was a 3/8 6061 plate, which fits the 9mm tooth width perfectly.
Each pulley took about 20 mins to do on the machine, this includes the .5 hex profile as the bore. The CAD model was downloaded from SDP SI's site. I could run thinner flanges, they were just the thinnest piece I had and I was setup for that operation on the machine so whatever.  Last edited by Mk.32 : 21-01-2013 at 14:55. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode