pic: Team 3824 Chassis Pic 2

… it’s all good as long as the kids are inspired. - AdamT [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
pic: Team 3824 Chassis Pic 2

Thread Tools

Rate Thread

Display Modes

06-02-2013, 16:58

Mike Marandola Mike Marandola is offline

Lead Bumper Mentor

AKA: Mike Marandola

FRC #0316 (Lunatecs)

Team Role: Mentor

Join Date: Jan 2009

Rookie Year: 2008

Location: Pedricktown, NJ

Posts: 657

Mike Marandola has a reputation beyond repute

Re: pic: Team 3824 Chassis Pic 2

Going off of the compressor (6") I was able to figure that the frame is roughly 22 inches wide. If a guard was added around the wheels on each side that was 3 inches, the width would then be bumped up to 28 inches. This would make the whole frame 28" x 28". This frame could very well be legal if something was added to make the wheels on the inside. Also the shafts look a bit to long so they could most likely be chopped which would give more wiggle room.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:16.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.