paper: FRC973 2009 and on robot CAD files

Are there any plans to release the CAD file for Hurricane?

[AdamHeard]

Yes, at some point we will get Hurricane and Encore posted.

[AdamHeard]

Added the drivetrain for Hurricane. We'll get something cleaned up and posted for the entire bot sometime down the road.

This CAD is pretty accurate for our drive, but doesn't show that we switched to 6" wheels down the road. We changed the gearing of the gearbox (kept the same plates) during this switch. We also had a kickup cylinder (dropped a ballcaster to the floor on one end) to get out of T-bone pins.

I have two .zips for Encore that aren't working in terms of uploading, I talked to Brandon about it and I'm sure we'll get it worked out.

[AdamHeard]

Adding more robots here...
https://drive.google.com/drive/u/0/f...DFYcWJQLXVoSjg

2015 and 2016 are up, will get 2012-2014, 2013 offseason, and Skystalker-er up at some point too.

[AllenGregoryIV]

Awesome, thanks Adam

[tim-tim]

Thanks for providing all of these great resources for teams.

On a side note, did you ever post the RAMP files that were used in the videos? A group of my students are working through the videos, but we haven't been able to find the files anywhere. The videos are really great. The students have learned a lot from them, and I even learned quite a bit.

[JesseK]

That is an impressive set of frame gussets in each corner of the robot. Thank you for the release!