pic: 20's IRI Carnage

[KrazyCarl92]

Originally Posted by apalrd

I still believe the cause of failure is improper material selection or component design more than anything else, not improper use of the gearbox (it should be able to handle this). 7075 is a significantly weaker material, and without changes to the dog design (e.g. increasing thickness, additional hardening, etc.) the overall strength is significantly lower vs stainless steel.

Thanks for the insight. Would there be any anticipated issues associated with making a part with similar geometry out of Stainless Steel and engaging it with the Aluminum gears or coupling to the 5/8" Aluminum hex shaft?