|
Re: pic: Introducing BarBox: My First Attempt at Gearbox Design
Quote:
Originally Posted by bardd
The output shaft sits on two different bearing sizes (0.875" in the back and 1.125" in the front)
|
Why is this necessary?
And a note on standoffs: It's very hard to find .375 OD tube with #10 clearance ID. Rather than buying .375 rod and drilling it out I prefer to buy .0625 wall with .375 OD and put .0625 deep counterbores in the plates to capture the standoff. Makes things much lighter and simpler to make.
Last edited by Adrian Clark : 27-07-2013 at 01:16.
|
Hurricane season would be torture, at least in snow you can lock the doors and know the robot is safe. - rtfgnow [more] 
27-07-2013, 01:07
Threaded Mode