|
|
|
 Now please, go have some meaningful discussions that will inspire us all. - Ken Leung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Now please, go have some meaningful discussions that will inspire us all. - Ken Leung [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: team2517's swerve
|
|
#2
15-01-2014, 07:46
|
|||
|
|||
|
Re: pic: team2517's swerve
Hum, almost looks like something I saw in our shop last night. Some changes since last time a pic was posted. I take it the team made the decision to go with swerve this year. If you did better get that mill crank'in, The shopping carts filled and the buy now button pressed . Choose the ship last week shipping option. Can you have a swerve module assembly party next week?
|
|
#3
15-01-2014, 12:01
|
||||
|
||||
|
Re: pic: team2517's swerve
If you did not see the other thread then yes it looks a lot like yours (the bottom half of it is almost completely yours plus a few small changes) it was the most reliable design that we could find, repackaged for better strength and to be less tolorance dependency. We have almost all the parts on hand and the mill started up yesterday we will have the first full test modular by sunday and a full drive by the sunday after. All we need is new belts and pullys.
Last edited by Tyler2517 : 15-01-2014 at 12:12.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
