|
|
|
 Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
29-10-2014, 02:02
|
||||
|
||||
|
Re: pic: Concept 6W Drive Train
Is there a particular reason why the corners of the chassis are cut off?
The only reason I can think of is if you're trying to make the chassis fit within the 112 inch frame perimeter. Otherwise, I don't see a structural benefit of cutting the corners off. Last edited by T-Dawg : 29-10-2014 at 02:14. Reason: grammar 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode