pic: Team 870 Suction Cups

Just like any good hardware or software product, "insert foot before putting mouth in gear"..... - dhitchco [more]

		Chief Delphi > FIRST > Robot Showcase
pic: Team 870 Suction Cups

Thread Tools

Rate Thread

Display Modes

27-02-2003, 06:40

sevisehda

Registered User

#0666

Join Date: Jan 2003

Location: The South

Posts: 215

sevisehda is an unknown quantity at this point

If your speaking of an L shaped bumper that pivoted in the bend its been done in the past. Except it was used to lift the agressing bot an inch or so off the ground so it would loose traction while the L bumper equipped bot would gain some.

I still don't see how your going to get suction if theres a gouge in the HDPE.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The Death of FIRST	Anton Abaya	General Forum	23	03-05-2006 17:18
pic: Team 870 Wiring Nightmare	CD47-Bot	Robot Showcase	15	02-03-2003 21:46
The 2003 Index of team's post about their robot...	Ken Leung	Robot Showcase	4	28-02-2003 00:18
pic: Team 870 Front Drive Train	CD47-Bot	Robot Showcase	4	27-02-2003 15:23
pic: Team 870 Rear Drive Train	CD47-Bot	Robot Showcase	2	27-02-2003 00:22

All times are GMT -5. The time now is 01:42.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.