|
|
|
 "Oblivious" people asking questions are what gives us an excuse to sit around on CD. - Ryan M. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| "Oblivious" people asking questions are what gives us an excuse to sit around on CD. - Ryan M. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#23
24-11-2014, 19:16
|
|||
|
|||
|
Re: pic: CV Robotics WCD 6wd Drivebase Prototype
I noticed how the 3 cims are really close to each other. How were you able to achieve this because I found that while its possible to get a small gap by using a smaller tooth gear, it wasn't possible to get such a small gap because you are limited by the bearing size (.375X.875 flanged bearing) which interferes with the placement of the cim motors.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode