pic: 610 Electronics Board

[Pretzel]

I can't help but see a spider when I look at that PDB with the wires arcing out towards the motor controllers. It looks very nice!

That's some clever usage of the power cables to disguise the PWM's that run underneath, I don't think I've seen that before, but it works well since the eyes are focused upon the larger wires above that are arranged into an aesthetically pleasing pattern.

One question: Is that a loop of extra wire I see just to the right of the VRM? Is there any specific reason that it is looped before going up and into the VRM, or was that just for looks?