|
Re: pic: Team 399 BellyPan
Very nice, very clean layout.
One suggestion - it looks, from the picture, that you have all of the pneumatics connected to the fitting on the compressor. You might consider moving them away and using a piece of tubing to connect the compressor to the pneumatics set.
In 2013, we had just a few components connected to that fitting and we cracked two of the compressor housings. That material is cast and is thin. We went through 3 compressors before we determined the cause was the stress on that part of the casting because that load will vibrate significantly while the compressor runs.
__________________
Chris Fultz
Cyber Blue - Team 234
2016 IRI Planning Committee
2016 IndyRAGE Planning Committee
2010 - Woodie Flowers Award - Championship
|
Lose a year of bumper making and everyone's a rookie again. - mrnoble [more] 
10-02-2015, 22:30
Threaded Mode