pic: FRC3880 - Tiki Techs - Electronics Board

[TikiTech]

Thanks so much for the comments.

The wire twist just takes practice. I have been using this technique for far longer than I care to share =)

The student that I have been mentoring has picked this technique up amazingly fast. Almost the same day I demonstrated it.
Shows what inspiration can do!! Let alone his desire to go beyond simple wiring layout with his research.

He created this layout based on where the electronics board sits in the robot and the other elements that make up the robot design.
He is inspiring me, a great trade for sure, this is what FIRST is about.. Inspiration going both ways!

I understand the changes you are posing, though the design fits a specific designated area.

There is power needed? Aww now we have to start over… time for a Ri3d

This layout has all be pulled out and the plate is being welded into the chassis tonight. Tomorrow it all goes back in along with its “missing” elements. I will post more as build progress and time permits.

Aloha and good luck to everyone this year!