|
|
|
 Maybe we should have some safety training before and during build instead of just having flyers at our pit. Hm... - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Maybe we should have some safety training before and during build instead of just having flyers at our pit. Hm... - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
16-03-2003, 21:32
|
||||
|
||||
|
A lot of those screws are ours from our drill transmissions! The 280 point round we had both drills simply took so much torque they... well, we found them all over the floor. Most of them.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Touching the ramp?! | CD47-Bot | Extra Discussion | 11 | 18-04-2003 05:23 |
| pic: Team #1020 On The Ramp | CD47-Bot | Robot Showcase | 1 | 14-04-2003 09:08 |
| pic: Robots racing up the ramp | CD47-Bot | Extra Discussion | 3 | 28-03-2003 14:53 |
| Pulling robot off ramp legal? | archiver | 2000 | 2 | 24-06-2002 00:14 |
| Technical question about ramp balancing | archiver | 2001 | 5 | 23-06-2002 22:29 |
Threaded Mode