|
|
|
 If people played without PDA's back when FIRST had this addiction to nigh-impossible-to-calculate-in-your-head multipliers, then we can play without PDA's now. - Ian Curtis [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
12-07-2015, 22:35
|
||||
|
||||
|
Re: pic: Four Speed Three CIM Gearbox
It looks quite well done for the project. It's not useful for competition, but it looks good anyway.
 Nice render too. For the top shaft of the gearbox, instead of using a hex bearing, I would round down the end of the shaft and use a round bearing. If you only have 2 standoffs going to the mounting plate, I would change it to 3-4. EDIT: +1 on the PTO idea. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode