|
|
|
 Getting a swerve to drive predictably and effectively is arguably harder than designing and building it.
- Holtzman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Getting a swerve to drive predictably and effectively is arguably harder than designing and building it.
- Holtzman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
17-12-2015, 12:19
|
||||
|
||||
|
Re: pic: Team 4522 Team SCREAM Swerve Module
Yeah. We have lathes. I was just looking on McMaster to find the broach and bushings. We have never broached key ways before but it doesn't look too difficult.
Any concerns with mounting the .500 in Hex directly to the CIM shaft? Here is what I think we would need to buy in order to broach correctly: 8mm reamer- http://www.mcmaster.com/#8851a23/=10a37ir 2mm keyway broach- http://www.mcmaster.com/#8805a11/=10a3730 8mm collared bushing- http://www.mcmaster.com/#8804a71/=10a36rr 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode