|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: 823543:1 Reduction Versaplanatery
|
|
#2
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Too funny!
If my quick calculations are correct, you'd have to wait 57 minutes to watch the output shaft make one revolution! |
|
#3
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
this will resolve any issue with back drive.
|
|
#4
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
But man, think of the torque implications that has!
|
|
#5
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Just *barely* falls off the load rating chart.
However you can always ship it back to Paul if you break it; you know, see what happens. |
|
#6
|
|||
|
|||
|
Re: pic: 823543:1 Reduction Versaplanatery
Should be fine if you ever need to pick up a truck...or a house.
|
|
#7
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
If only the internal gearing on the final 3 stages and the 1/2" hex output shaft could carry the torque!
![]() 261,000 foot-pounds of torque could lift every single robot in FRC together... still with a 12" spool. Of course, you'd want to use like a 3" spool so it could still lift at peak power, not stall... and it'd take about 2 and a half hours... and 254's stockpile of batteries. Last edited by Nathan Streeter : 01-21-2016 at 10:22 AM. Reason: Accounted for lifting every robot in FRC without frying the motor... don't worry about the failed gearbox though. ;-) |
|
#8
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
This looks like something 71 would be responsible for
![]() |
|
#9
|
|||||
|
|||||
|
Re: pic: 823543:1 Reduction Versaplanatery
So have you found the screws yet? Reminds me of this https://www.youtube.com/watch?v=VUbpb23yTK8
|
|
#10
|
|||||
|
|||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Do you even torque?
|
|
#11
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
or a boulder...
|
|
#12
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Congratulations; you almost just made yourself the world's torquiest hour hand.
|
|
#13
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Ahh... the old long con...
|
|
#14
|
||||
|
||||
|
Why climb up to the scaling rungs when you can move the entire field down to your robot's height?
|
|
#15
|
||||
|
||||
|
Re: pic: 823543:1 Reduction Versaplanatery
Too funny. At least that team member is learning the idea of gear ratios. haha
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|