pic: 3641-2016 Off-season Swerve Project (If we ever get around to it lol)

[SerpentEagle]

Originally Posted by adciv

You're showing the old D-Link radio/AP/4-port Switch on the robot. This item was replaced as of this year with the 2-Port OM5P.

Originally Posted by frcguy

http://www.andymark.com/FRC-Radio-OM5P-AC-p/am-3205.htm

Yeah I know. Were on a budget so we decided to use the old radio since we already have a brand new one lying around.

Also, due to changes in fcc regulations, the frequency that the d-link uses is technically illegal!

[EmileH]

Also, there's a blue PDB on your electronics board! Do you plan on making your own terminating resistor for the CAN chain (as I see you have Talon SRX's which I assume are being used for CAN since that provides feedback)? We typically use the PDP as the terminating resistor for our CAN devices.

[SerpentEagle]

Originally Posted by EmileH

Also, there's a blue PDB on your electronics board! Do you plan on making your own terminating resistor for the CAN chain (as I see you have Talon SRX's which I assume are being used for CAN since that provides feedback)? We typically use the PDP as the terminating resistor for our CAN devices.

I modeled both (the new one is transparent in the render) since were not sure yet what were going to use. Budget is tight for us so were trying to use what we already have. Our electronics guys said it wouldn't be hard to add one by ourselves, but if all else fails we'll just be forced to buy the new pdp