pic: 4908 Prototype West Coast Drive

Didn't you know, I can be in two places at once? - Andy Baker [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
pic: 4908 Prototype West Coast Drive

Thread Tools

Rate Thread

Display Modes

20-12-2016, 12:39

Chris Hapstack Chris Hapstack is offline

Design Mentor

FRC #0342 (Burning Magnetos)

Team Role: Mentor

Join Date: Apr 2015

Rookie Year: 2007

Location: Charleston, SC

Posts: 34

Re: pic: 4908 Prototype West Coast Drive

It looks like the gearbox output shaft is direct-driving the center wheel. If so, is there enough room to back out/remove a gearbox after the whole thing is assembled without taking the frame apart? The spacing between the back sides of the gearboxes seems tight (but then again, I can't measure it).

__________________

2017 -------- Team 342 mentor (Charleston, SC)
2015-2016 - Team 85 mentor (Zeeland, MI)
2007-2010 - Team 281 student (Greenville, SC)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:45.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.