pic: Version 1.2

[Arefin Bari]

Originally Posted by Tytus Gerrish

that cylinder rod is going to bend if the gears Jam, try moving the cylinder so the piston so its in line with the shifter shaft, that means taking it out of the box. but at least it wont make you have to take your gearbox apart remove the old cylinder, find a new one and put it all back together before your next match when you bend it.

Thanks Tyty, i was thinking about it. i do have a feeling that something is going to bend. i think i am going to move the cylinder outside. i do have to think about it a bit more before i change anything. stay tune for V 1.3

[Greg Perkins]

Arefin,

since i've been working with you on these designs, i have seen what seemed like a rookie design turn into what seems to be a high class design. A few things im still hoping you change, is that you adapt the cylinder so it sits inside the box more and takes up less space. HOWEVER...everything seems to be amazing and FIRST class


keep up the good work, and "your welcome"

[Tom Bottiglieri]

could you move the cylnider so it is sitting on top of the shifting gear instead of taking up space over on the side?

[Arefin Bari]

Originally Posted by Tom Bottiglieri

could you move the cylnider so it is sitting on top of the shifting gear instead of taking up space over on the side?

great idea tom, sure i can do that. but in order to do that i have to extend the plate. i dont see anything wrong with it. at this point, i am not worried about having the tranny go a little bigger, i want to perfect it.