pic: "Omni Grenade" Wheel

D.Fahringer · #16 10-12-2004, 09:37

Quote:

Originally Posted by Stu Bloom

I am definitely interested an any CAD files you have available. If you can "publish" them - and post to the white papers it would be greatly appreciated!

GREAT looking wheels!!

Thanks, I will get the files together, and zip them up.

Here is the Mold and drill fixture used...the brass sleeve (not shown) fits on the center pins. The drill fixture assures a good hole location every time!
The holes were finished with a flat bottom before tapping. The 5/16-18 tap was modified to get thread all the way to the bottom. The bolts were faced on the ends and completely bottom out in the hole.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Team 60 Wheel Design	CD47-Bot	Extra Discussion	6	18-11-2004 19:57
pic: 885 Right-center wheel and drive assembly	CD47-Bot	Robot Showcase	2	30-04-2004 18:27
pic: 6 wheel drive train pick	CD47-Bot	Robot Showcase	3	14-04-2004 07:10
pic: 296's Tri-Star Wheel	CD47-Bot	Robot Showcase	23	16-02-2004 11:27
pic: da wheel	CD47-Bot	Robot Showcase	11	08-02-2004 22:04