|
|
|
 It's about compressing life into 6 weeks. It's about doing. It's about learning to fail. It's about gracious professionalism. It's about releasing the limitations that we all put on ourselves. It's about thinking outside of the box. It's about growing. - JohnBoucher [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
04-02-2005, 14:48
|
|||||
|
|||||
|
Re: pic: 610 Teaser Part 3
Looks like it is bolted to a piece of aluminum angle that also has mounting holes thru its horizontal flange surface. I would guess that the center hole is just slightly oversized so that a 1/2 or 5/8 diameter shaft can spin freely inside, and this assembly is used as your wheel/axle bearing (or bearing for some other shaft).
Of course this would be a bit easier if the picture were in focus  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Teaser pic from team 25 | Wayne C. | Rumor Mill | 43 | 22-02-2004 12:23 |
| pic: 781 - Teaser 5 | CD47-Bot | Robot Showcase | 21 | 19-02-2004 13:40 |
| pic: Team 1053's very first ever teaser pic | CD47-Bot | Robot Showcase | 3 | 16-02-2004 22:56 |
| pic: 2004 ComBBAT Teaser | CD47-Bot | Robot Showcase | 6 | 16-02-2004 20:12 |
| pic: 1024 Teaser | CD47-Bot | Extra Discussion | 7 | 08-02-2004 10:10 |
Threaded Mode