pic: Sorting drill bits

[M. Hicken]

I had the same job earlier this year. I was getting annoyed by the ziploc bags of random bits, and the large indexs we had laying around. Of course, they were empty. I was using a caliper at first, but after i realized that alot of the bot shanks were messed up by people who dont know how to tighten a chuck, i just went down to work and "borrowed" the drill bit gague. I sorted about 2000 bits in an hour. I wish our freshamn were competant enough to do that job.

[Kyle]

I remember doing that job, it was the only way I learned how to find the right drill bit. That is a hard job though cause people always come up and take a bit then just drop it on the table near you so you have to find where it goes all over again. I hate it when the size is all rubbed off and you have to use the calipers to get it right. But its all good.

[Projectchon]

Nice..nice...too nice that makes me mad