pic: ball laucher

Bemis · #1 06-02-2006, 22:36

They are six inches, I believe, same as our drive wheels, so not that small. We had no trouble with the wheels demolishing balls though. There isnt a whole lot of compression on them.

Arkorobotics · #2 07-02-2006, 17:35

Hey, what part did you use to connect those wheels to the shaft of the CIM motor?

Cody Carey · #3 07-02-2006, 17:57

http://www.chiefdelphi.com/forums/sh...619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls

Arkorobotics · #4 07-02-2006, 20:41

Quote:

Originally Posted by Cody C

http://www.chiefdelphi.com/forums/sh...619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls

go to McMaster and type in 2469k2, would that work? or would i rip up in place?

Cody Carey · #5 07-02-2006, 22:40

I would use the keyed one, or add a setscrew for each shaft, but yeah... That would probably work quite well

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Center Player Station and Ball Drop	Wetzel	Extra Discussion	2	08-01-2006 17:40
pic: Team 980 grabs 2X ball 3 seconds into Galileo QF3.1	CD47-Bot	Extra Discussion	9	06-05-2004 02:31
2X Ball Into the Ball Release	MikeDubreuil	Rules/Strategy	23	28-03-2004 19:31
pic: 2003 TechnoKat Ball Drive : Patent Pending	CD47-Bot	Robot Showcase	78	30-03-2003 16:27
pic: Ball Drive Close Up	CD47-Bot	Robot Showcase	17	04-03-2003 15:23