|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: Revenge of the Chain Fighter
so I assume that's an omni-wheel?
|
|
#2
|
|||||
|
|||||
|
Re: pic: Revenge of the Chain Fighter
Yea this is an omni wheel to a vex robotic team that I helped mentor last fall.
|
|
#3
|
||||
|
||||
|
Re: pic: Revenge of the Chain Fighter
Did you guys have to make that chain piece by piece too? I had to make three of those chains on inventor, it took about 4 days to finish, because the computer slowed way down after I got about 25 inches on it. It was really annoying to make those darn chains, piece by piece, I thought I would lose any sanity that I had left by the end of it.
|
|
#4
|
||||
|
||||
|
Re: pic: Revenge of the Chain Fighter
hey did you ever got your vex chains to work, i have been working with the vex chains for a while and i cant never get the rigth number of pieces to make it tigth so it can work
natalia |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chain Tensioners | sanddrag | Technical Discussion | 24 | 25-02-2006 19:39 |
| How To Make Chain With Inventor 10 | vVigglEs | Inventor | 6 | 28-01-2006 21:34 |
| dismanteling a chain | Amittt | Technical Discussion | 11 | 26-01-2006 11:06 |
| Chain Drive chain | Damelvin | 3D Animation and Competition | 2 | 15-02-2005 00:19 |
| Titanium chain & sprokets | rubicondsrv | Kit & Additional Hardware | 16 | 27-01-2005 13:00 |