pic: Team 1872

[Armando Gonzalez]

we only have problems of the balls coming out of the goal when the goal has too many balls inside

[EricH]

Do you have any problems with ball escaping sideways in the harvester? Also, are you guys sure your flag holder (I'm assuming it's the little tube behind the collector) is high enough? You need to have the top of a 3-foot tube at least 1 foot above your robot, but less than 6 feet, and held by a 1-foot tube. By my calculations (using the ball in the picture and guesstimating), you need it about a foot higher. Other than that, nice and simple.

[Armando Gonzalez]

Originally Posted by EricH

Do you have any problems with ball escaping sideways in the harvester? Also, are you guys sure your flag holder (I'm assuming it's the little tube behind the collector) is high enough? You need to have the top of a 3-foot tube at least 1 foot above your robot, but less than 6 feet, and held by a 1-foot tube. By my calculations (using the ball in the picture and guesstimating), you need it about a foot higher. Other than that, nice and simple.

na the ball doesn't escape sideways on the harvester, the belt is runing so fast that it only takes a second for one ball to get in. And thanks a lot about the tube thing, I did not know that it had to be a foot over the robot

[Adam Richards]

Great looking bot! I'm definitely going to have to swing by your pits take a look at this next Thursday.

[YonZ]

I like your use of gravity

very interesting choice about control panel though, it's the first time I haven't seen victors, controllor, etc nowhere near the base.

[nehalita]

looks great! can you go up the ramp? do you have an autonomous?
can't wait to see it at UCF

[Armando Gonzalez]

yeah we can go up the ramp, the back part of the robot is pushed by a piston; so it goes up and we can go up the ramp easily

the piston is not showed on this picture, we added it afterwards

[Tazlikesrobots]

Goo luck my fellow Boriquas!