|
|
|
 Bottom line: I would suggest that you walk a mile in our shoes and volunteer to be an inspector at your next event... - Mike Betts [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Bottom line: I would suggest that you walk a mile in our shoes and volunteer to be an inspector at your next event... - Mike Betts [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
05-07-2006, 17:53
|
||||
|
||||
|
Re: pic: Possible Board Design 1
This violates the FIRST logo standards. Why not comply to said standards and just make it a square board (with slightly curved corners), and put the logo in large in the center with the grace space.
I am guessing this is for FIRSTopoly? Last edited by Morgan Gillespie : 05-07-2006 at 17:55. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 696 Control Board | hayakuneko | Extra Discussion | 2 | 05-03-2006 19:37 |
| Lights in Joystick board or control board | rcubes85 | Control System | 15 | 26-02-2005 23:40 |
| Electronics Board Construction/Design | zdeswarte | Electrical | 10 | 28-01-2005 00:09 |
| pic: Possible Team 114 Drive Component | James114 | Extra Discussion | 14 | 15-01-2005 12:27 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode