|
|
|
 I'm pretty sure Andrew Baker and Andy Baker are the same person. Then again, Andy may just be holding out on us. - Amanda Morrison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm pretty sure Andrew Baker and Andy Baker are the same person. Then again, Andy may just be holding out on us. - Amanda Morrison [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
25-08-2006, 21:44
|
|||
|
|||
|
Re: pic: IFI-WHEEL v2
This past year at the Cleveland regional there were issues with the IFI wheels passing inspections. Mainly the inspectors were worries about once the tread wore down that the metal on the sides and the rivets that were used to attach the tread. Will this still be an issue with this design? And if so, are you working with FIRST to assure that this years wheels will not have the same issue?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Bent IFI Wheel | Kate00 | Extra Discussion | 19 | 03-04-2006 02:28 |
| pic: Dented IFI Wheel | Jeff K. | Extra Discussion | 11 | 08-03-2006 20:36 |
| Attaching Treads to IFI Wheel | natis | Kit & Additional Hardware | 8 | 05-02-2006 21:07 |
| pic: Victor/IFI Logo | B. Flaherty | Extra Discussion | 4 | 01-02-2006 22:40 |
| pic: Chantilly Academy's 4 Wheel Drive 4 Wheel Steering!!!! | jskene | Robot Showcase | 25 | 18-02-2005 20:24 |
Threaded Mode