|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: Joe Troy studying the atlas ball
|
|
#2
|
||||
|
||||
|
Re: pic: Joe Troy studying the atlas ball
. . something about that big ball reminds me of the Indiana Jones
|
|
#3
|
|||||
|
|||||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
Sorry Joe, don't hurt me. I just had to. |
|
#4
|
|||||
|
|||||
|
Re: pic: Joe Troy studying the atlas ball
How difficult was it to push the atlas ball around?
does anyone know how much it weighs? |
|
#5
|
||||
|
||||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
|
|
#6
|
|||||
|
|||||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
- The ball in the picture was out of round and the weight was off center - Smaller robots tended to drive under the ball - Obstacles (softballs, other robots) on the opposite side of the ball often became wedges - Robots pushing on opposite sides of the ball, regardless of the pushing power of the robots, and especially when under the hanging bar were a complete standoff The atlas ball will play a role in this game in addition to its value as a multiplier. ![]() |
|
#7
|
||||
|
||||
|
Re: pic: Joe Troy studying the atlas ball
How hard is it to reset the field? I'm imagine those softball stacks to be troublesome, especially if they rolled into other stacks and start a chain reaction.
|
|
#8
|
|||||
|
|||||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
![]() |
|
#9
|
|||||
|
|||||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
Last year it was possible that 100 balls had to be reset and those pesky lines were troublesome. We also lost time between matches last year with robots "slipping" down the hill from their starting positions. This year we have the potential to reset 40 balls in piles of four on the field with six balls for preloading. While it might not be obvious to you, every place where a pile of four softballs starts is at an intersection of tiles (and most are also marked by the white tape). Also note that the bottom three softballs in a stack are set in "random orientation" so we take out the need for an overly precise reset position. After that, all that needs to be reset are the atlas ball, and a quick rotation of the platform. I can only speak for the Delaware event with certainty, but DE and many others will use two fields. This means that one match will run while the other field is being reset. So, if you factor in the folks we needed last year on the autonomous field that no longer exists, our prediction is that these events should be able to have a quicker reset between matches and use the same number of reset volunteers as were used last year. Last edited by Rich Kressly : 19-09-2006 at 11:57. |
|
#10
|
|||
|
|||
|
Re: pic: Joe Troy studying the atlas ball
Quote:
I agree with Joe Troy that teams need to pay special attention to the atlas ball. Due to the unbalanced nature of the ball a robot can push it one way and have it roll back or to the side. Teams should be prepared for the ball to move in an unpredictable manner. The last 10 seconds are going to be very exciting, especially if the ball is near the centerline since it will wobble for a good 5 -10 seconds before it settles down enough to be counted. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Closeup of atlas ball | Carol | FIRST Tech Challenge | 6 | 19-09-2006 23:47 |
| pic: Got the ball and the goal | CD47-Bot | Robot Showcase | 3 | 12-07-2004 22:08 |
| pic: 16 placing the 2x ball on the stationary goal | CD47-Bot | Extra Discussion | 4 | 30-03-2004 12:37 |
| Teams in the Albany/Troy/Rensselaer area? | Dan-o | General Forum | 5 | 15-04-2003 23:25 |