|
|
|
 This only gets awkward when the girl knows more digits of pi than you do... - Walter Deitzler [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This only gets awkward when the girl knows more digits of pi than you do... - Walter Deitzler [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
13-01-2007, 23:24
|
|||
|
|||
|
Re: pic: Bike Cim + 56 mm gearbox
When i imported both assemblies into solidworks i had to remate all the parts of the motor and tranny, did you have the same problem? Any ideas on how to aviod this problem? This could save me some time later on in my designing, for example, the victor speed controller imports as like 60 separate parts and i dont want to have to go thru and remate all of the parts.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| pic: BIKE NYC! | Rich Wong | Extra Discussion | 5 | 12-05-2006 13:17 |
| New Model Posted - Mini Bike Motor | Ed Sparks | Inventor | 0 | 18-01-2006 23:03 |
| Poll: CIM vs. Bike Motor? | Swan217 | Motors | 18 | 14-01-2006 13:02 |
| Gearbox that can be used inline with a CIM | bombadier337 | Motors | 3 | 11-03-2005 22:05 |
Threaded Mode