|
|
|
 These are threads, and they are what hold the community together...so CD must be a threaded fastener right? - Andrew Blair [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| These are threads, and they are what hold the community together...so CD must be a threaded fastener right? - Andrew Blair [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
21-02-2007, 17:56
|
||||
|
||||
Re: pic: 832 Finished Robot
It goes up ramps quite well. We had it go up a 30 degree incline (al dia plate) here at school. Also has a smaller that average footprint.
The manipulator was cut on a band saw. See you at Peachtree |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 296 Finished Robot | Pat Fairbank | Robot Showcase | 7 | 23-04-2006 23:26 |
| pic: Team 1501 finished robot | Wayne Doenges | Robot Showcase | 11 | 31-03-2006 20:02 |
| pic: 1493 Finished robot | Dan-o | Robot Showcase | 10 | 24-02-2005 23:20 |
| pic: Finished robot | Matt_Kitts | Robot Showcase | 1 | 23-02-2005 11:49 |
| pic: 1073 Finished Robot | Petey | Robot Showcase | 5 | 13-02-2005 00:57 |
Threaded Mode