|
|
|
 There's so much to say about a sponsor who gets involved and cares about your team over one who just signs a check. - galewind [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There's so much to say about a sponsor who gets involved and cares about your team over one who just signs a check. - galewind [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
26-07-2007, 21:26
|
|||||
|
|||||
|
Re: pic: Custom Machined Aluminum #25 Sprocket
Are those radiused areas in the center contoured?
Or do they just happen to be the same radius as a ball endmill you ran through there? Those are some sick sprockets. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: MVRT1115 small machined parts | Ashwin | Extra Discussion | 5 | 23-02-2007 13:22 |
| pic: 254/968 Machined Parts | Cory | Robot Showcase | 11 | 12-02-2007 07:42 |
| pic: Team 1538's Machined Parts (C) | Jon Jack | Extra Discussion | 19 | 23-01-2007 02:06 |
| pic: 1538's Machined Parts (B) | Jon Jack | Extra Discussion | 2 | 21-01-2007 20:31 |
| #25 Aluminum Sprocket Source | Don Wright | Kit & Additional Hardware | 1 | 26-01-2005 13:41 |
Threaded Mode