|
|
|
 A challenge to those of you grumbling about the refereeing this year: Be a referee next year. - Alan Anderson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A challenge to those of you grumbling about the refereeing this year: Be a referee next year. - Alan Anderson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#21
07-08-2007, 15:01
|
|||||
|
|||||
|
Re: pic: Bad Brad with a 3D Print
I sometimes cheat with making flexible parts by 3D printing a cast/mold model and then fill the cavities with a rubber or plastic. There are many places to 3D print parts (google), its a matter of how much one is willing to spend. Also, figure out just how much support material the method of 3D printing leaves behind, it can be very time consuming to remove.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| quation problem with Transmission vary bad fraction slepy | yara92 | Electrical | 4 | 03-02-2007 11:34 |
| pic: Basic "foot print" of Robot | falconmaster | Extra Discussion | 7 | 18-01-2006 18:30 |
| Print F statement | brownster | Programming | 7 | 20-02-2005 01:58 |
| How "bad" are motors with "bad" stickers? | cooknl | Kit & Additional Hardware | 20 | 12-01-2005 10:33 |
| Anyone else with a really bad robot? | Lord Nerdlinger | General Forum | 49 | 08-04-2004 22:20 |
Threaded Mode