|
|
|
 If I had a dollar for every time I thought we'd get a legitimate hint....Well, I might have a few dollars... - Andrew Blair [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If I had a dollar for every time I thought we'd get a legitimate hint....Well, I might have a few dollars... - Andrew Blair [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#29
17-08-2007, 11:18
|
|||
|
|||
|
Re: pic: Bad Brad with a 3D Print
A lower cost solution? (I found this website and immediately thought of this thread.)
Home built ~$500 machine with $0.37/pound material. But there is a BIG "yeah, but..." attached to these prices. (It's sugar!)  I forgot to add that this "printing" is exciting. Wish I had it many moons ago building architectural models in college.... Last edited by Roger : 17-08-2007 at 11:21. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| quation problem with Transmission vary bad fraction slepy | yara92 | Electrical | 4 | 03-02-2007 11:34 |
| pic: Basic "foot print" of Robot | falconmaster | Extra Discussion | 7 | 18-01-2006 18:30 |
| Print F statement | brownster | Programming | 7 | 20-02-2005 01:58 |
| How "bad" are motors with "bad" stickers? | cooknl | Kit & Additional Hardware | 20 | 12-01-2005 10:33 |
| Anyone else with a really bad robot? | Lord Nerdlinger | General Forum | 49 | 08-04-2004 22:20 |
Threaded Mode