|
|
|
 "There's plenty of room on the top for everyone" ... it's not a top if everyone is there. - Alyssa [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "There's plenty of room on the top for everyone" ... it's not a top if everyone is there. - Alyssa [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
10-09-2007, 13:22
|
||||
|
||||
|
Re: pic: 294 Prototype Base frame rail - almost done
Looks like 6061 with a 1/2 in endmill judgeing by the size of the slots and finish of the alumnium. I could be totally wrong though. BCR you guys are great. Adam good luck with that chasis design it is quite the project and will be worth it in the long run. Looking good so far with those frame rails reminds me of a west coast version of a 233 chasis.
 Good stuff, Drew Last edited by techtiger1 : 10-09-2007 at 13:22. Reason: I don't think a 1/2 mill exists lol 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: FRC294 Prototype base | AdamHeard | Extra Discussion | 18 | 07-09-2007 15:22 |
| pic: Team 294 Base | AdamHeard | Extra Discussion | 9 | 21-04-2007 21:22 |
| pic: FEA - Stress Analysis of Frame Rail | kramarczyk | Extra Discussion | 5 | 01-02-2007 16:29 |
| pic: Team 294 Wheel prototype | AdamHeard | Extra Discussion | 5 | 09-10-2006 01:44 |
| Pic: Team 20 almost done | Ein | Robot Showcase | 2 | 16-02-2005 20:55 |
Threaded Mode