pic: Pulley? - Chief Delphi

12-01-2008, 16:58

Kevin Sevcik Kevin Sevcik is offline

(Insert witty comment here)

FRC #0057 (The Leopards)

Team Role: Mentor

Join Date: Jun 2001

Rookie Year: 1998

Location: Houston, Texas

Posts: 3,574

Kevin Sevcik has a reputation beyond repute

Send a message via Yahoo to Kevin Sevcik

Re: pic: Pulley?

Dyano,

When do you need this, and what exact dimensions and material are you looking for? We've got a lathe, broaching set, and a load of aluminum stock. If it's not going to weigh more than a pound, we could turn it out and mail it to you. If it's heavier, we'd probably have to figure out a way to run it up to austin. We've got an ex team member that's attending UT that might not have left Houston yet, however, so let me know ASAP what we're looking at here, and I'll try to hook you up.

__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Team 48 Drive Pulley	A_Reed	Extra Discussion	2	29-01-2007 12:26
Large CIM motor pulley size/series?	Tim Skloss	Technical Discussion	3	09-01-2007 22:36
big CIM pulley	Rickertsen2	Motors	1	18-01-2006 11:41
Timing Belt and Pulley	Joe_Widen	Technical Discussion	4	16-01-2006 13:41
Gear and Timing Pulley Design Resources	Madison	Technical Discussion	2	08-05-2003 21:01

All times are GMT -5. The time now is 08:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.