|
|
|
 Tolerance, forgiveness, humor, and lessons learned are tools we can find here. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Tolerance, forgiveness, humor, and lessons learned are tools we can find here. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: Team 401 Drivetrain Teaser
Hmm.... I'll mention getting real bearings for the drive wheels... but I think that pillow blocks should be fine for the non-drive wheels.
4 inch wide drive wheels are small by 401 standards. Tetrabot had 6 inchers, and Shooterbot had 5, I believe. You can't see half the frame in the shot, BTW, and I think the frame is unevenly placed on the table. We have maybe a hair under an inch of clearance. Enough to jump the gap. 
|
|
#2
28-01-2008, 23:24
|
|||
|
|||
|
Re: pic: Team 401 Drivetrain Teaser
Wow it looks really nice but.. how much clearance do you have?
 It doesn't look like much. Our clearance is about 1 inch and I thought that was low. I would if I was you change out those plastic pillow blocks like everybody has stated. Otherwise you may be doing a lot of working after evey few rounds. Been there done that!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 401 FRAME TEASER - OVERDRIVE | ggoldman | Extra Discussion | 6 | 08-02-2008 06:51 |
| pic: Team 401 - Teaser #2 | ggoldman | Robot Showcase | 7 | 12-02-2007 00:37 |
| pic: Team 401 - Teaser # 1 | ggoldman | Robot Showcase | 1 | 11-02-2007 01:41 |
| pic: Team 612 Drivetrain Teaser #1 | Pnakovich | Extra Discussion | 5 | 25-01-2007 22:06 |
| pic: Team 461 Drivetrain Teaser | Nikhil Bajaj | Robot Showcase | 2 | 11-02-2006 07:15 |
Hybrid Mode
