|
|
|
 The version that finished nationals was about 50% aluminum and 50% the original PVC and we never had any member break. (structural member, not team member). - Gary Dillard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
20-02-2008, 07:53
|
|||
|
|||
|
Re: pic: lift setup
bleh, numbers haha. i know its a 16 from the CIM to a 84 on a driveshaft connected to the driven pulley of a 32 that runs the belts.
it raises to about 120-ish inches in about 2 seconds under load 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scissort Lift vs. Crane vs. 4-Bar Lift vs. Gas Springs | AdamC | Technical Discussion | 31 | 20-01-2008 18:49 |
| pic: Tempest 'N Tampa Field Setup | Stephen Kowski | Extra Discussion | 2 | 30-09-2007 22:03 |
| pic: 1261's GuitarHero/Xbox control setup | Adamskiy | Extra Discussion | 13 | 20-03-2007 12:22 |
| pic: Brazilian Invitational field setup | Manoel | Extra Discussion | 4 | 16-05-2005 14:01 |
Threaded Mode